Figure 8
• The device can be used at altitudes up to 2000 m above sea level.
• There is no need to remove side panels in the combi boiler service
operations. Minimum 50 mm clearances are given taking into consideration
the share of possible side panel sheet changes.
• Do not install your boilers in locations that will be exposed to direct
sunlight. Sunlight can cause color change on the exterior of your device
over time.
• Ambient temperature of device's installation location should be between
5-35°C.
Since the outside temperature of the device does not rise above 85 ° C at the maximum heating power,
no special protective measures are required against the combustible construction materials and
components.
8. INSTALLATION
8.1. Selection of Installation Location of Device
The boiler must be installed in accordance with gas safety regulations and relevant standards.
Additionally, the clearance around the boiler should be as shown in figure 8. In order to make service,
maintenance and usage easier.
Figure 8: It shows the minimum distances required from the top and sides of the device (Dimensions
given in mm).
The installation must comply with the following minimum distances so that servicing and maintenance
of the boiler can be performed correctly. The position of the boiler must be checked against technical
requirements.
INFORMATION
INFORMATION
INFORMATION
INFORMATION
To Next Page
Loading...
