EAE EE-6503V2 User Manual (English)

Questions and Answers:

K
Kaitlyn RyanAug 3, 2025
What to do if the EAE EE-6503V2 motor runs but will not raise?
- C
  Caitlin SchmidtAug 3, 2025
  If the motor runs but the EAE Scissor Lifts won't raise, consider these potential causes and solutions: * Check the wire connection, as the motor might be running in reverse. * Clean or adjust the overflow valve if it's jammed or not well screwed up. * Replace the gear pump if it's damaged. * Add oil if the oil level is too low. * Tighten the hose connection if it's loose. * Clean or adjust the cushion valve if it's jammed or not well screwed up.
S
Steven PowellAug 9, 2025
Why is my EAE Scissor Lifts raising too slow?
- M
  Michelle MaxwellAug 9, 2025
  If your EAE Scissor Lifts are raising too slowly, the following could be the reasons: 1. The oil filter might be jammed, so clean or replace it. 2. The oil level might be too low, so add oil. 3. The overflow valve is not adjusted to the right position, so make an adjustment. 4. The hydraulic oil might be too hot (above 45°), so change the oil. 5. The seal of the cylinder might be abraded, so replace the seal.
R
rbellAug 14, 2025
What to do if EAE EE-6503V2 platforms go down slowly after being raised?
- J
  Jared DelgadoAug 15, 2025
  If the platforms of your EAE Scissor Lifts descend slowly after being raised, it could be due to several issues: * The oil hose might be leaking, so check or replace it. * The oil cylinder might be untightened, so replace the seal. * The single way valve might be leaking, so clean or replace it. * The solenoid valve might not be working well, so clean or replace it. * The unloading valve might be leaking, so check and adjust the tightness.
T
Tiffany HubbardAug 20, 2025
How to fix EAE Scissor Lifts that is lowering too slow?
- E
  Eric JohnsonAug 20, 2025
  If your EAE Scissor Lifts are lowering too slowly, consider the following potential causes: * The throttle valve may be jammed, so add grease. * The hydraulic oil may be dirty, so clean or replace it. * The anti-surge valve may be jammed, so change the oil. * The oil hose may be jammed, so clean it.