Eagle CUDA 350 S/MAP - Page 136

128
1. Press
WPT|→ to NEW|ENT.
2. Press ↓ to
AVERAGE POSITION|ENT|↑ to CREATE|ENT.
3. Wait while the unit takes points to average the position. The greate
r
the number of points, the greater the accuracy. When the desired numbe
r
of points accumulate, press ENT to create and save the waypoint.
4. The Edit Waypoint menu appears. You can save the waypoint b
y
pressing EXIT or you can edit the waypoint.
Set a Waypoint by Projecting a Position
This feature sets a waypoint at a specific distance and bearing from a
reference position. The reference position can be selected from you
r
waypoint list, a map feature or from the Points of Interest list.
1. Press
WPT|→ to NEW|ENT.
2. Press ↓ to
PROJECTED POSITION|ENT|↑ to CREATE|ENT.
3. Press ↓ to
SET REFERENCE|ENT, which will launch the Select Point
menu with three options: My Waypoints, Map Places and Highway Ex-
its. Highlight the desired category and press
ENT. The Find By menu
will appear. Choose the desired option: Find by Nearest or Find B
y
Name and press ENT. Use ↑ ↓
to select a waypoint or map feature.
When the point has been selected, press
ENT|ENT and its position ap-
pears as the reference position.
4. Press ↑ to
DISTANCE|ENT. Use ↑ ↓
to change the first character, then
press → to the next character and repeat until the distance is correct.
Press
ENT.
5. Press ↓ to
BEARING|ENT. Use ↑ ↓
to change the first character, then
press → to the next character and repeat until the bearing is correct.
Press
ENT.
6. Press ↓ to
PROJECT|ENT. The Edit Waypoint menu appears. You can
save the new projected waypoint by pressing
EXIT or you can edit the
waypoint. Press
ENT to navigate to the new waypoint.