79
Sonar Simulator
This unit has a built-in simulator
that will allow you to practice as
though you were on the water. All sonar features and functions will be
useable during a simulation. When in simulator mode, you will see
[Simulator Mode] in the Sonar Page title bar. To use the simulator:
1. From the Sonar Page, press
MENU|MENU|↓ to SONAR SETUP|ENT.
2. Select
SONAR SIMULATOR ON and press ENT. If you want to simulate you
position, highlight SIMULATE POSITION and press ENT, which will turn on
the GPS Simulator.
NOTE:
If you turn on your unit before attaching a transducer, it may ente
a demo mode. The words demo mode flash on the bottom of the
screen and a sonar chart will play. Unlike the simulator, the demo
mode is for demonstration only and will automatically stop as soon
as you turn on the unit with a transducer attached. The simulato
will continue to function normally.
Stop Chart
If you are running multiple units on a boat, there are times when you
may want to turn off the sonar. This command turns off the sonar an
stops the chart from scrolling. Sonar restarts automatically each time
you turn on your unit.
Press
MENU|↓ to STOP CHART|ENT|EXIT.
To turn the sonar on again, repeat the step above.
To Next Page
Loading...
