13
Section 2: Installation
Preparations
ou can install the sonar and GPS systems in some other order if you
prefer, but we recommend this installation sequence:
CAUTION:
You should read over this entire installation section before drill-
ing any holes in your vehicle or vessel!
1. Determine the approximate location for the sonar/GPS unit, so you
can plan how and where to route the power
transducer cable. This will
help you make sure you have enough cable length for the desired con-
figuration.
2. Determine the approximate location for the transducer and its cable
route.
3. Determine the location of your battery
or other power connection,
along with the power cable route.
4. Install the transducer and route the transducer cable to the so-
nar/GPS unit.
5. Route the power cable from the unit's location to an appropriate
power source and connect it there.
6. Connect the transducer/power cable to the unit and mount the so-
nar/GPS unit to the bracket.
Transducer Installation
These instructions will help you install your Skimmer
®
transducer on a
transom, on a trolling motor or inside a hull. Please read all instruc-
tions before proceeding with any installation.
To Next Page
Loading...
Need help?
General
