Eagle T20CF - User Manual

Questions and Answers

D
Dustin RichardsonAug 4, 2025
How to fix Eagle T20CF when adhesive tape doesn't cut properly?
- J
  Jeffrey WheelerAug 4, 2025
  If the adhesive tape doesn't cut properly, it could be due to several reasons. The blade might be too high, which can also cause scrape marks on the carton; in this case, lower the cutting blade. Alternatively, the blade could be too low, so raise the cutting blade. Another possibility is that the cutter force is too low. If so, adjust the tension of the cutter force spring on the blade shelf.
S
Scott GardnerAug 12, 2025
What to do if adhesive tape does not adhere to the carton on Eagle T20CF Industrial Equipment?
- J
  Jeffrey OlsenAug 12, 2025
  If the adhesive tape isn't sticking to the carton, there could be a few reasons. First, check the unidirectional rubber wheel; if it's broken, replace it. Second, if the head of the back adhesive tape is wiping unevenly, adjust the speed of the press/wipe belt cylinder. Finally, if the adhesive tape is wrinkled, adjust the force of the extension spring of the front rubber wheel.
B
Brittany AndrewsAug 19, 2025
Why is there a suction and placement of carton error on my Eagle Industrial Equipment?
- L
  Laura CurryAug 19, 2025
  A suction and placement error can occur for several reasons. The air pressure might be out of range, so adjust the supply air pressure to match the machine's requirements. A suction disk malfunction could also be the cause; inspect the suction disk for proper alignment, cracks, or deformities. Lastly, the suction fixture might be misaligned; verify and adjust it as necessary.
T
Tammie WilliamsAug 27, 2025
How to troubleshoot when the carton does not feed properly in Eagle T20CF?
- D
  Danielle JohnsonAug 28, 2025
  If the carton isn't feeding correctly, it might be because the spacing of the catch pin is too narrow; in this case, adjust the catch spin spacing. Another reason might be a suction feed system malfunction; check the suction disks for defects or damage and replace them if needed.