3.1 Transportation
Use a fork lift or tow motor to remove the machine from its shipping container or pallet.
3.2 Tape Head Installation
Remove the front supporting shaft. Rest the rear of the tape head on the rear supporting shaft. Place the front
supporting shaft on the angled notches in the front of the tape head and lower the tape head down guiding
the pin into the notches in the frame.
Check tape cutter position and adjust as needed.
3.3 Connect Power Supply
Connect the machine to the power supply.
Note: Prior to connecting the machine to the power supply, verify that the power switch is set to the ‘OFF’
position and that the work area is clean and clear of any items.
To Next Page
Loading...