- Defective Zone Bypass & Alert:
If the security system is armed at the same time that an input is active (such as a door opening
or hood / trunk opening ), you will hear one siren chirp to indicate arming and after 5 seconds
a second siren chirp to indicate bypass Notification. A Bypass Notification chirp means that the
security system ignores the input that was active when the system was armed, until that input
ceases.
Note: You may press 2-way remote button once to check again which zone is not closed.
- Arm without siren chirp : Press the button over 2sec.
You may temporarily to arm your system without siren chirp , to operate it by simply press and hold
the button for over 2sec. until the remote give 1 beep sound, then release the button .
The system will armed and without one siren chirp.
Note: this features is only activated under the system is in disarmed and Acc off position,.
Standard features
the status LED will flash approximately once per
second, indicating that the system is actively protecting your vehicle.
- To ARM the system: Press the button once.
To arm your system within proper operation range, simply press button once (while
system in disarmed or Acc off position) . The system will respond one siren chirp, one lights
flash, doors lock, disable engine starter,
2-way LCD display :
Defective zone Siren chirps 2-way beeps 2-way LCD indicator
Door opened 4 chirps 1 long + 3 short
Trunk opened 5 chirps 1 long + 4 short
Hood opened 6 chirps 1 long + 5 short
IMMO icon
indicate that
the engine
blocked
To Next Page
Loading...
