Eaglemaster E8 - Disarming without a transmitter; Disarming by using the PIN code; Silent arming mode

- Silent arming mode : Press the button over 2sec.
Simply press the button
1+2 over 2sec.. The system will armed without siren chirp. Disarm the system the siren will
be automatically returned into the normal mode.
To temporarily turn off the arm or disarm chirps, use Silent mode.
Note: The Zone1 and Zone 2 sensors are bypassed if the system is armed using Silent
Mode. This ensures that no chirps will be emitted by the siren in an area you want chirp-free.
The system is still fully capableof triggering. Only the sensor is bypassed.
- Disarming without a transmitter :(table-1 of No.6 Valet sw status)
The security system can be disarmed without the remote transmitter. The function
is provided for the case when you need to disarm the system and drive the car but the
Remote transmitter is faulty or lost. If while the programming of the system for the manual
disarming the Valet (table-1 of No.6) was selected act as follows to disarm the system:
open the car door - the security system will be triggered and the siren will be turned on; turn
on the ignition, press the Valet switch once to disarm the system.
- Disarming by using the PIN code :(table-1 of no.6 PIN code status)
To select the PIN coded disarming mode. Please contact your installation technician or see
Functions to be programmed section and the Installation manual. If the coded disarming
mode is on you can use the manufacturer code (25) or to provide the maximum arming of
your car you can program your own PIN code for disarming at any time. The code comprises
two digit; each digit can vary from 1 to 9.
To disarm the system using the PIN code
1. Open the door with the key (the system will be triggered and the parking lights will go on
and so on).
2. Turn ON the ignition .
3. Press the Valet button 2 times , the number of times which is in accordance with the first
digit of your PIN code (the manufacturer setting is 2 time).
4. Turn OFF the ignition then turn ON again.
5. Press the Valet button 5 times, the number of times which is in accordance with the
second digit of your PIN code (the manufacturer setting is 5 time).
6. System will automatically disarmed if insert the correct PIN code.
Note:
If you enter the wrong code , you must wait next cycle triggering and turn off the ignition
then start from step #2.
2-way LCD display :
+ One beep sound