Manage Engine start /running features
This system has several important safety input to ensure proper operation of the motor and
prevent accidental damage to the engine or its components.
If one of the under list input is defective , the engine will not allow to start.
- The hood switch is opened.
- The Hand brake switch off
- Not in Park switch gear position.
- Safe status :
- Safety mode for manual-type car: Press the button over 2sec.
This safety feature for the car with manual-gear type (Table-3 of NO 4), before set the
engine start mode, you have to set the system in Safety mode.
To set safety mode:
1. In safe status, Engine running , press the button for over 2sec.
2. The parking lights will active to indicate in safety mode.
3. Remove the ignition key, and leave the car , however the engine still running.
4. Arm the system, and the 2-way LCD will indicate Safety icon as under:
Note: this Safety mode will turn OFF if door switch opened when arming.
- Safety mode :
Arming the system the 2way remote will turn on the safety mode icon , it will allow to
engine start if the icon is turn on. If one of the zone's been triggered, the icon will turn off
and engine start is not available . It will able to engine start by next arming again.
2-way LCD display :
Icon on if the
safety mode active.
- Remote start : Press the button over 2sec. then press once.
This feature allows you to remotely start and run your vehicle for a programmable period of
time. This makes it possible to warm up the engine, as well as the system is in Safe status.
Important!
(1) Never remote start your vehicle when the keys are in the ignition, except when
performing "Arm with engine run mode", and (2) Never start the vehicle if it is not in Park
switch gear position and not Hand brake on .
To Next Page
Loading...
