Eaglemaster E8 - Page 35

Note: How to programme No.5~No.8 timer output
While in programme item No.5~No.8 ,to programme the channel timer output by pressing
the button or , at the time the siren will give chirps and the LED will steady ON ,
the programmer now is in counting time (from 1~120sec.) , after your desire time, pressing
the button or again, thus the channel has been programmed the time output.
No.1
No.2
No.3
No.4
No.5
No.6
No.7
No.8
Item NO. by
LED flash
Door switch delay while
arming
Controlled channel (-) CH-5
output
Controlled channel (-) CH-1
output
Controlled channel (-) CH-2
output
Controlled channel (-) CH-3
output
Controlled channel (-) CH-4
output
Manage door lock/unlock
1-chirp
2-chirp 3-chirp 4-chirp
Press button
Press button Press button Press button
Press the
Valet SW
to next item
PROGRAMME
FEATURES
PROGRAMME TABLE-2
60sec.
45sec.
5sec.
15sec.
0.8sec.
3.5sec.
Lock-
0.8sec.
Unlock-
2pulse
Lock-
30sec.
Unlock-
0.8sec.
Interlock
N/C Type
Armed output
Interlock
N/C Type
Armed output
Interlock
N/O Type
Disarmed
output
Interlock
N/O Type
Disarmed
output
Exchange CH-1/CH-2 &
Lock / Unlock channel .
Lock output = gray wire (-)
Unlock output = white/black wire (-)
CH-1 output = internal lock relay
CH-2 output = inter unlock relay
ON
ON
OFF
OFF
Trunk open
Pulse output
1sec
Remote
latched
by key-1
Remote
latched
by key-1+4
Remote
latched
by key-2+4
Remote
latched
by key-3+4
Disarming
Pulse
output
30sec
Arming
Pulse output
30sec
Programme
time output
1~120sec.
sensor off
Programme
time output
1~120sec.
sensor off
Programme
time output
1~120sec.
sensor off
Programme
time output
1~120sec.
sensor off
Programme
time output
1~120sec.
sensor on
Programme
time output
1~120sec.
sensor on
Programme
time output
1~120sec.
sensor on
Programme
time output
1~120sec.
sensor on
2nd stage
unlock