EasyIO SH-TSX - System Configuration Parameters

SH-TSX Product Manual - © EasyIO / www.easyio.eu
22
option fitted)
1 = Enabled (default)
Show Unit Swap
Centigrade to Fahrenheit Temperature
Mode Selection on the Home Screen.
0 = Disabled (default)
1 = Enabled
Sensor 1 Text
Description for the Sensor1 (RI1/Network)
Default; 0 = DisabledNote: Disabled
removes Sensor1 Text and Measurement
from Display
0 = Disabled
1 = Room
2 = Floor
3 = Outside
4 = Zone 1
5 = Zone 2
6 = Zone 3
7 = Bathroom
8 = Sauna
9 = Bedroom
10 = Kitchen
11 = Cooler
12 = Flow
13 = Hot Water
14 = Tank
15 = Pool
16 = Cabin
Sensor 2 Text
Description for the Sensor2 (RI2/Network)
Default; 0 = DisabledNote: Disabled
removes Sensor1 Text and Measurement
from Display
Sensor 3 Text
Description for the Sensor3 (Built-In
Sensor/Network)Default; 1 = RoomNote:
Disabled removes Sensor1 Text and
Measurement from Display
Setpoint Mode
Sets the unit of the target parameter
0 = Temperature (default)
1 = Percentage
2 = None (no setpoint
displayed)
Disable ECO Button
Disables the user cancel of the ECO mode
0 = Enabled (default)
1 = Disabled
System
Parameter name
Description
Range
Address
Modbus Address (Only Modbus
versions)
BACnet MAC Address (Only
BACnet versions)
0..247 (Default 1)
0..127 (Default 1)
Baud Rate
Modbus / BACnet Baud Rate
0 = 9600 (Default)
1 = 19200
2 = 38400
3 = 57600
4 = 76800
Parity
Parity
0 = None (Default)
1 = Odd
2 = Even
Stop Bits
Stop Bits
0 = 1 Stop Bit (Default)
1 = 2 Stop Bits
Device ID (Only BACnet
versions)
BACnet Device ID
0..4, 194, 303
(Default Auto=651001
Service Pin (Only BACnet
versions)
Bacnet Service Pin (when
activated the device sends
BACnet I-AM message)
0 = Disabled (default)
1 = Enabled
Maintenance Code
Maintenance Mode Password
0000 - 9999 (default 6666)
Staff Code
Staff Page Password - Access
Password to Further Settings
Screen
0000 – 9999
(default 0000 = disabled)
Language
Default Language for User
Screens
0 = English (Default)
1 = Finnish
2 = Swedish