Eaton 9140 - Display Functions

OPERATION
Eaton
®
9140 (9910-E82/E83) UPS Installation Guide for IBM
®
Applications S 164201715 Rev 2
www.eaton.com/ibm
43
Display Functions
When the UPS starts up, the LCD displays the Eaton logo and the type
of UPS.
About 5 seconds after startup or after 15 minutes of inactivity, the LCD
displays the system status screen. The system status screen shows the
output voltage, output frequency, output load percent, and the current
operating mode (see Figure 33 on page 41).
The backlit LCD automatically dims after a long period of inactivity. Press
any button to restore the screen.
From the system status screen, press the
button to select MENU.
Use the two middle buttons (
and ) to scroll through the menu
structure. Press the
button to select an option or enter a submenu.
Press the
button to cancel or return to the previous menu.
The following table shows the basic menu structure.
Table 9. Menu Map for Display Functions
Main Menu Submenu Display Information or Menu Function
Control
Output Control Turn the UPS on and off / Transfer to other modes
Battery Test Cancel a test / Schedule a test / View a test report
Status
Active Alarms Display any active alarms
UPS Output Display the voltage, current, frequency, load, current, watts, and VA
UPS Input Display the current utility voltage and frequency
Battery Display the current positive and negative battery voltages, percent battery
charge, and expected battery runtime in minutes
DC Link Display the current positive and negative rail voltages
System Display the system runtime (days/hrs/min/sec)
Alarm History Display the most recent 50 events and alarms, by description, alarm
number, and time (day/hr/mins/sec in system runtime).
Model Info UPS Type / UPS Serial Number / UPS Part Number / Firmware Version
Setup
User Setup See Table 10 for detail.
Service Setup This screen is password-protected.