Eaton 93PM Series User Manual

Eaton 93PM UPS 480V Three-Wire – 100 kW Frame Installation and Operation Manual 164000227—Rev 07 9
11..99 GGeettttiinngg HHeellpp
If help is needed with any of the following:
• Scheduling initial startup
• Regional locations and telephone numbers
• A question about any of the information in this manual
• A question this manual does not answer
Please call the Customer Reliability Center at:
United States:
1-800-843-9433
Canada:
1-800-461-9166 ext 260
All other countries: Call your local service representative
Please use the following e-mail address for manual comments, suggestions, or to report an error in this
manual:
E-ESSDocumentation@eaton.com
11..1100 EEqquuiippmmeenntt RReeggiissttrraattiioonn
Please visit www.eaton.com/pq/register to register your new Eaton UPS / Eaton UPS Accessory.
Model Number:
Serial Number:
Introduction

Eaton 93PM Series Specifications

General

Topology	Double conversion online
Form Factor	Modular
Frequency	50/60 Hz
Power Factor	0.99
Operating Temperature	0°C to 40°C
Relative Humidity	0-95% non-condensing
Efficiency	Up to 97% in double conversion mode, 99% in ESS mode
Communication	RS-232, USB, SNMP, Modbus
Overload Capability	150% for 1 minute
Output Frequency	50/60 Hz
Battery Type	VRLA, Lithium-ion
Audible Noise	<65 dB at 1 meter
Protection Features	Overload, short circuit, over temperature
Input Voltage	208V, 480V
Output Voltage	208V, 480V
Storage Temperature	-15 to 50°C (5 to 122°F)