UPS System Installation
Eaton 93PM UPS (20–50 kW, 480V Four Wire – 50 kW Frame) Installation and Operation Manual P-164000540—Rev 4 www.eaton.com/powerquality 4-5
Figure 4-3. Removing the Sidecar Rear Shipping Bracket – Eaton 93PM UPS
4.3 Integrated Battery Cabinet Installation
If installing Integrated Battery Cabinets (IBCs), refer to the Eaton 93PM Integrated Battery Cabinet Installation
Manual-Large and Large High Rate, the Eaton 93PM Universal Integrated Battery Cabinet Installation
Manual-Large and Large High Rate, or the Eaton 93PM Integrated Battery Cabinet Installation Manual-Small,
listed in paragraph 1.8, for installation instructions.
After the IBC is installed, proceed to paragraph 4.4 if a Sidecar Integrated Accessory Cabinet-Bypass (SIAC-B)
is attached to the UPS.
4.4 Sidecar Integrated Accessory Cabinet-Bypass Wiring Installation
If an SIAC-B is attached to the UPS, refer to the Eaton 93PM Sidecar Integrated Accessory Cabinet-Bypass
Installation and Operation (50 kW and 100 kW SIAC-B) Manual, listed in paragraph 1.8, for wiring installation
instructions.
After the SIAC-B is wired, proceed to paragraph 4.5 to complete the wiring of the UPS.
To Next Page
Loading...
