UPS System Installation
Eaton 9E UPS (40–60 kVA, 208/220V) Installation and Operation Manual P-164000058—Rev 4 www.eaton.com/powerquality 4-13
4.11 Installing Interface Connections
4.11.1 Installing Building Alarm Connections
To install wiring:
1. Verify the UPS system is turned off and all power sources are removed. See Chapter 6, “UPS Operating
Instructions,“ for shutdown instructions.
2. To locate the appropriate terminals and review the wiring and termination requirements, see
paragraph 3.2.3, Table 4-1, Figure 4-10, Figure 4-11, and Figure 4-12.
Figure 4-10. Interface Terminal Locations
Mini-Slot Communication Bays
(See Figure 4-11 for detail)
Interface Terminals
(See Figure 4-11 for detail)
Top Rear Panel
Back
To Next Page
Loading...
