Eaton 9PX Lithium-Ion User Guide DPD-9PX2206—Rev 01 7
Table 4. LCD Operating Status (Continued)
Operation status Cause Description
Battery mode
A utility failure has occured and the UPS
is on Battery mode.
The UPS is powering the equipment with
the battery power. Prepare your
equipment for shutdown.
End of backup time
The UPS is on Battery mode and the
battery is running low.
Low Battery Warning settings:
[Capacity] [0%] ... [100%]
The alarm triggers when the set
percentage of battery capacity or
remaining back-up time is reached.
High Efficiency mode
The UPS is operating on High Efficiency
mode.
The UPS is powering and protecting the
equipment
Bypass mode
An overload or a fault has occurred, or a
command has been received, and the
UPS is in Bypass mode.
Equipment is powered but not protected
by the UPS.
22..66 DDiissppllaayy FFuunnccttiioonnss
Press the ( ) button to activate the menu options. use the two middle buttons ( and ) to scroll through
the menu structure. Press the (
) button to select an option. Press the ESC button to cancel or return to the
previous menu.
Table 5. Display Functions
Main menu Submenu Display information or Menu function
Measurements
[Load] [Input] [Bypass] [Output Efficiency] [Battery] [DC Bus] [Average Power Usage]
[Cumulat.Power Usage] [BMS Information]
Control
Go to Bypass Transfers the UPS on Bypass mode
Start battery test Starts a manual battery test
Reset fault state Clears active fault
Restore factory set Returns all settings to original values
Reset average
power
Clears average power usage measurement
Reset cumul.
power
Clears cumulated power usage measurement
Dry contacts test Tests dry contact relay outputs
BMS Auto Setup UPS will auto dectect the EBM quantities only when the UPS powered on for the first
time. If the quantity of EBMs is reduced, UPS will report BMS comm. loss. If the quantity
is increased, UPS cannot actively identify it. In those time, the user can select "BMS auto
setup" to manually refresh the battery quantity.
Display Functions
To Next Page
Loading...
