Eaton 9PX6K-L - User Settings

8 Eaton 9PX Lithium-Ion User Guide DPD-9PX2206—Rev 01
Table 5. Display Functions (Continued)
Main menu Submenu Display information or Menu function
Settings
Local settings
Sets product general parameters
In/out settings Sets Input and Output parameters
On/Off settings Sets On/Off conditions
Battery settings Sets battery configuration
Event Log
Event filter Selects faults, alarms and/or events to display
Event list Displays the events stored
Reset fault list Clears events
Fault log
Fault list Displays the faults stored
Reset fault list Clears faults
Identification
[Product type/model] / [Part/Serial number] / [UPS/NMC firmware] / [Com card IPv4], [Com
card IPv6], [Com card MAC]
Registration Links to Eaton registration website
22..77 UUsseerr SSeettttiinnggss
The following table displays the options that can be changed by the user.
Table 6. User Settings
Submenu Available Settings Default settings
Local
Settings
Language
[English] [Français] [Deutsch] [Español] [Русский] [Simplified
Chinese] Menus, status, notices and alarms, UPS fault, Event Log
data and settings are in all supported languages.
[English] User
selectable when UPS is
powered for the first
time.
Date/ time
Format: [International] [US] [US]
LCD Modify LCD screen brightness and contrast to be adapted to room
light conditions.
Audible alarm
Mode: [Enabled] [Disabled on battery] [Always disabled] Enable or
disable the buzzer if an alarm occurs. Level: [High] [Low]
[Enabled] [High]
Protected
Access
[Enabled] [Disabled] Usage of password to access to Control,
Settings, Event logs Fault logs menus. If it is enabled, the password
is fixed and cannot be changed by user, the Password is 0577.
[Disabled]
In/Out
settings
Output voltage [200V] [208V] [220V] [230V] [240V] [208V]
Output
frequency
Frequency converter: [Enabled] [Disabled]
Frequency settable in frequency converter mode
[Disabled]
Output mode
[Industrial] [Network]
Set UPS behavior regarding transfer on Bypass
[Network]
Input volt
hysteresis
Sets input voltage hysteresis from [1] to |10V] [10V]
User Settings