39INSTALLATION AND OPERATION MANUAL 25-16328-B November 2020 www.eaton.com
Section 3: Panel controls & indicators
Pre-Alarms
Enter the Supervisor Mode and Select “Pre-Alarms” tab.
A pre-alarm is shown when a detector appears to register heat or smoke but in a
quantity that is insufficient to warrant an alarm.
Pre-alarm may indicate a build up of dirt in a smoke detector which can be
interpreted by the detector as smoke presence.
Disabled devices
Enter the Supervisor mode and Select the “Disabled” tab.
The individual buttons show which devices and the number of devices which
have been disabled. Press one of the buttons to display detailed information for a
particular category.
Supervisor
FRE Off
Evacuate
Fires
AC = 0
Pre-alarm = Some smoke /heat but below fire threshold
These warnings will appear and disappear
View Pre
Alarms
View
Disabled
View
Faults
Others
Silence
Alarms
Mute
Buzzer
Reset
Fires
AC = 0
View Pre
Alarms
I/O
Zone: 0
Addresses: 0
Touch button to
View list
View
Disabled
View
Faults
Others
Supervisor
FRE Off
Evacuate
Silence
Alarms
Mute
Buzzer
Reset
To Next Page
Loading...
