Eaton DF61002 - Test Device (Access Level 3)

50 INSTALLATION AND OPERATION MANUAL 25-16328-B November 2020 www.eaton.com
Section 3: Panel controls & indicators
Test device (access level 3)
To activate the touch screen, touch the top left corner of the screen until the screen
illuminates. To enter the service mode touch the supervisor button and enter
supervisor passcode.
Service
FRE Off
Mute
Buzzer
Reset
Configure
Enable / Disable Address
Commission
Test
Mute
Buzzer
Reset
001 Lobby, Build 1, 1st floor
Loop: 1, Zone: 2, Type: Optical
002 Main Reception, Building 1, 1st floor
Loop: 1, Zone: 2, Type: Optical
003 Storage/archive, Building 1, 1st floor
Loop: 1, Zone: 2, Type: Optical
004 Meeting Room 1, Building 1, 1st floor
Loop: 1, Zone: 2, Type: Optical
Show
All
Service
FRE Off
Service
FRE Off
Exit
Global Flashing LED on/off
Test Zone
Sounder Level Test Mode
One Man Walk Test
Test Device
Show
Detectors
Show
I/O Units
Reset
Show
Alarms
Touch row to test
Go to
Exit
Enter the Service
mode. Select“Test”.
Select the “Test
Device” button.
Loop 1, Address: A
Yes
No
Test Device
Loop 1, Address: A
Previous
Done
No
Test Device