Eaton DF61002 - Viewing Events

47INSTALLATION AND OPERATION MANUAL 25-16328-B November 2020 www.eaton.com
Section 3: Panel controls & indicators
Viewing events
To activate the touch screen, touch the top left corner of the screen until the screen
illuminates. To enter the supervisor mode touch the supervisor button and enter the
passcode.
Enter the Supervisor Mode Passcode. Select the “Others” tab and press View Log.
Use the scroll bar to view the list of upto 1000 events.
The Panel event log stores up to 1000 events including, fires, faults, resets and
address changes. Once the maximum 1000 events has been reached Panel will
automatically overwrite the oldest event every time a new event is stored. The event
log can only be reset by an approved service engineer.
Supervisor
FRE Off
Evacuate
Silence
Alarms
Mute
Buzzer
Reset
Fires
AC = 0
View Pre
Alarms
View
Disabled
View
Faults
Others
Weekly Test
Send Log to PC
Enable/Disable
View Log
Check Config
Print
Send analogue values to PC
Lamp test
Supervisor
FRE Off
Evacuate
Newest
Show
All
Show
Fires
Show
Faults
Show
Tests
ExitOldest
001 Monday 13-Jan-2004 08:34:12
Hard Reset
002 FIRE! Lobby, [Optical] (Ana=150)
Building 1, Ground floor, Panel 1, Loop 1, device 1
003 Monday 06-Nov- 2000 11:22.56
Soft Reset
004 Monday 13-Nov-2001, 18:09.07 Fault
Panel1, Loop 2 Zone 2, Address 5
005 Monday 18-Feb-2001 22:20.18
Mains or Battery failure
Silence
Alarms
Mute
Buzzer
Reset
Events can be sorted
by selecting from the
sort option menu.