Eaton DF61002 - Global Flashing LED On;Off

53INSTALLATION AND OPERATION MANUAL 25-16328-B November 2020 www.eaton.com
Section 3: Panel controls & indicators
Global flashing LED on/off
To activate the touch screen, touch the top left corner of the screen until the screen
illuminates. To enter the supervisor mode touch the supervisor button and enter the
service passcode.
Enter the Service Mode and Select Test.
If global LED flashing is set to
on, all device LED’s will pulse
intermittently to confirm correct
communication.
Select “Global Flashing LED On/
Off” from the Test Menu Screen.
Global flashing LED on/of
Flashing Off
Service
FRE Off
Mute
Buzzer
Reset
Configure
Enable / Disable Address
Commission
Test
Mute
Buzzer
Reset
Service
FRE Off
Exit
Global Flashing LED On/Off
Test Zone
Sound Level Test Mode
One Man Walk Test
Test Device