48 INSTALLATION AND OPERATION MANUAL 25-16328-B November 2020 www.eaton.com
Section 3: Panel controls & indicators
Check auto config
To activate the touch screen, touch the top left corner of the screen until the screen
illuminates. To enter the supervisor mode touch the supervisor button and
enter the passcode.
Enter the Supervisor Mode and Select the “Others” Tab. Press Check Auto Config.
This feature will scan the loop and pinpoint the exact location of any break in the loop
wiring and will also identify any changes in the loop configuration (e.g. New devices
added or changed device types).
Supervisor
FRE Off
Supervisor
FRE Off
Supervisor
FRE Off
Evacuate
Silence
Alarms
Mute
Buzzer
Reset
Fires
AC = 0
View Pre
Alarms
View
Disabled
View
Faults
Others
Weekly Test
Send Log to PC
Enable/Disable
View Log
Check Config.
Print
Send analogue values to PC
Lamp test
Check Auto Config
Replace Device
Exit
Check
Auto Config
Press the
Supervisor
Mode
button at
the top left
of the
screen.
Yes
No
To Next Page
Loading...
