Appendix
04/10 MN04020001Z-EN
190
System parameters
Hard- and Software Information
S1.1
833 - ro API SW ID - 128 0
S1.2
834 - ro API SW Version - 128 0
S1.3
835 - ro Power SW ID - 128 0
S1.4
836 - ro Power SW Version - 128 0
S1.5
837 - ro Application, ID - 128 0
S1.6
838 - ro Application, revision - 128 0
S1.7
839 - ro System load % 128 0
Communication
S2.1
1)
808 - ro Communication status In xx.yyy format
xx = Number of error messages
(0 - 64)
yyy = number of correct messages
(0 - 999)
128
S2.2
1)
809 / rw Error bus protocol 0 = FB disabled
1 = Modbus RTU
128 0
S2.3
1)
810 / rw Slave address 1 - 255 128 1
S2.4
1)
811 / rw Baud rate 0=300
1=600
2=1200
3=2400
4=4800
5=9600
6 = 19200
7 = 38400
8 = 57600
128 5
1) These parameters are overwritten with the bus-specific parameters when a fieldbus connection (e.g. CANopen) is used. The parameter values
described in the manual of the fieldbus interface then apply.
S2.6
813 / rw Parity type 0 = None, no a 2 Stop bits
1 = Even, a 1 Stop bit
2 = Odd a 1 Stop bit
129 0
S2.7
814 / rw Communication timeout 0 = Not used
1 = 1 s
2 = 2 s
…
129 0
S2.8
815 / rw Reset communication
status
0 = Not used
1 = resets parameter S2.1
129 0
Unit counter
S3.1 827 - ro MWh counter MWh 129 -
S3.2
828 - ro Operating days 0 - 0000 days 129 -
S3.3
829 - ro Operating hours 0 - 24 h 129 -
S3.4
840 - ro RUN counter, days 0 - 0000 days 129 -
S3.5
841 - ro RUN counter, hours 0 - 24 h 129 -
S3.6
842 - ro FLT counter Trip Counter: 0 - 0000 129 -
PNU ID Access right Designation Value range Page FS
(P1.3)
User
setting
RUN ro/rw
To Next Page
Loading...
