04/10 MN04020001Z-EN
Commissioning with control
signal terminals (factory
setting)
59
As an alternative (OR) to operation via control signal terminals,
you can also operate the frequency inverter without connecting
the control signal terminals by simply switching the control level
and the setpoint value input.
The following brief instructions indicate the required steps.
Figure 59: Start-Stop command with maximum setpoint value voltage, acceleration ramp 3 s
t
t
f
max
~ n
max
f
P6.5 = 3 s P6.8 = 0
FWD
REV
+24 V
= 50 Hz
0
P6.4
a
RUN STOP
LOC/REM button
LOC = local, keypad (KEYPAD)
REM = remote (I/0, BUS)
LOC
REM
To Next Page
Loading...
