Eaton MP-3000 - Page 19

Effective 10/02
Page 4-8Page 4-8
For more information visit: www.cutler-hammer.eaton.comIL17562BH04
Help Message
GROUNG FAULT ALARM LEVEL IN % OF
GROUND CT RATIO NUMERATOR
I2T ALARM LEVEL IN % FULL OF I2T
TRIP CAPACITY
JAM ALARM LEVEL IN % FLA
JAM ALARM RUN DELAY IN SECONDS
UNDERLOAD ALARM LEVEL IN % FLA
UNDERLOAD ALARM RUN DELAY IN
SECONDS
PHASE UNBALANCE ALARM LEVEL
PHASE UNBALANCE ALARM RUN
DELAY IN SECONDS
STARTS PER TIME ALLOWED
TIME ALLOWED FOR STARTS COUNT
IN MINUTES
TIME BETWEEN STARTS IN MINUTES
NUMBER OF COLD STARTS ALLOWED
MOTOR START TRANSITION CURRENT
LEVEL IN % FLA
MOTOR START TRANSITION TIME IN
SECONDS
TRANSITION ON EVENT
TRN TIME – ON TIME ONLY,
TRN I – ON CURRENT ONLY,
TRN T+C – ON TIME OR CURRENT,
TRN T/C – ON TIME AND CURRENT
Selected
Value
Section
Reference
5.4.1
5.4.2
5.4.3
5.4.4
5.4.5
5.4.6
5.4.7
5.4.8
5.5.1
5.5.2
5.5.3
5.5.4
5.5.5
5.5.6
5.5.7
Value
as
shipped
OFF
80
1000%
2
OFF
10
10
10
1
OFF
OFF
1
130
10
TRN T+C
Display
GFA XXX
I2TA XXX
JMA XXXX
JMAR XXX
ULA XXX
ULAR XXX
UBA XXX
UBAR XXX
ST/T XXX
T/ST XXX
TBS XXX
NOCS X
TRNC XXX
TRNT XXX
Choose:
TRN TIME
TRN I
TRN T+C
TRN T/C
Line
No.
1
2
3
4
5
6
7
8
1
2
3
4
5
6
7
Setting
Range/ Value
Selection
2-55% of Ground
CT ratio numerator,
OFF (1%
increments)
6-99%, OFF (1%
increments)
100-1200%, OFF
(1% increments)
0-240 sec. (1 sec.
increments)
6-90%, OFF (1%
increments)
0-240 sec. (1 sec.
increments)
4-40%, OFF (1%
increments)
0-240 sec. (1 sec.
increments)
1-10 starts/time
(increments of 1)
1-240 minutes,
OFF (1 minute
increments)
1-240 minutes,
OFF (1 minute
increments)
1-5 starts (incre-
ments of 1)
10-300% (1%
increments)
0-1200 sec. (1
sec. Increments)
Choose one of the
four conditions
that determine a
start-to-run
transition: TRN
TIME, TRN I,
TRN T+C, or TRN
T/C.
Refer to settings
P5L5 and P5L6.
Page 5 SP START SETTINGS FOR START EVENTS
Page 4 SP ALARM SETTINGS FOR ALARM EVENTS