DG1 Series Overview
PowerXL DG1 Series Option Cards MN040007EN—April 2014 www.eaton.com 3
Option Card Slots
The control board is located inside the control unit of the DG1
Series Drive. There are two slots, labeled A and B, on the
control board. The different option boards can be added to
any slots. When the DG1 Series Drive is assembled at the
factory, no option boards are installed in slots A and B. If an
incorrect board is plugged into either slot, the board will not
work, but there is no danger to personnel or for equipment
damage.
Option Board Summary
There are a total of five I/O option cards available on the DG1
that can be placed in either Slot A or B.
●
IO1 = 3 DI, 3 DO, 1 thermistor, 24 Vdc / EXT
●
IO2 = 1 AI, 2 AO (isolated to control board)
●
IO3 = 3 Relay Dry Contact (2 NO and 1 NO / NC)
●
IO4 = Qty. 3 PT100 RTD input
●
IO5 = 6 DI 240 Vac Input
Figure 3. Drive Control Board Layout Showing Option Card Slots
Connect DSP Part
to Power Board
Keypad
Connect MCU Part
to Power Board
Battery (Standard)
RJ45 EtherNet/IP,
BACnet, Modbus TCP
Option Card Slot A
Option Card Slot B
RS-485 Termination
Resistor
Removable
MOV Screw
Motor Ground
Clamp Location
Grounding
Strap Location
Grounding
Strap Location
Line Ground
Clamp Location
Removable
EMC Screw
Control
I/O Terminals
AI Mode
Selection
STO
Fan
Power Wire
Line Side Motor
To Next Page
Loading...
