Eaton Power XL DG1 Series - IO1 Board Parameters; IO1 Monitor Menu Parameters; IO1 Parameter Menu Configuration

IO1—3 x DI, 3 x DO, 1 x Thermistor, 24 Vdc/EXT Option Card
16 PowerXL DG1 Series Option Cards MN040007EN—April 2014 www.eaton.com
IO1 Board Parameters
Table 10. IO1 Board Parameters
Note: X is indicating that it could be in slot A or slot B, which would change the value shown.
Monitor Menu—BX.1
Code Parameter Min. Max. Default Unit ID (Slot A / Slot B) Description R / RW
BX.1.1 DI1, DI2, DI3 889 / 915 Digital Input Status R
BX.1.2 DO1, DO2, DO3 888 / 914 Digital Output Status R
BX.1.3 Thermistor State 887 / 913 Thermistor configure R
BX.1.4 Thermistor Resistor 891 / 917 Thermistor resistance value R
Parameter Menu—BX.2
Code Parameter Min. Max. Default Unit ID (Slot A / Slot B) Description R / RW
BX.2.1 DO1 Function Select 0 241 / 244 Selects the function for the digital output RW
BX.2.2 DO2 Function Select 0 242 / 245 Selects the function for the digital output RW
BX.2.3 DO3 Function Select 0 243 / 246 Selects the function for the digital output
RW
BX.2.4 Thermistor Configuration 0 1 0 890 / 916 Configures the thermistor as active
0: Digital Input
1: Thermistor Input
RW