Eaton Power XL DG1 Series - IO1 Thermistor Input Configuration; Thermistor Input States and Settings

IO1—3 x DI, 3 x DO, 1 x Thermistor, 24 Vdc/EXT Option Card
PowerXL DG1 Series Option Cards MN040007EN—April 2014 www.eaton.com 15
Thermistor Input
The signal thermistor input needs to be configured
before use. It will switch states at 4.7 k ohm.
Table 9. Thermistor Input Configuration
Figure 12. Thermistor Parameter Setting
PTC Resistance PTC State
>4.7K Open
1.8K to 10 Normal
<10 Short
No PTC Not Configured