Eaton Power Xpert 9395 - Using the LCD Control Panel

154 Eaton Power Xpert 9395 UPS Installation and Operation Manual 164201725—Rev 15
Figure 100. UPS Controls and Indicators
Pushbutton
Control Panel
ISBM
AC Input Breaker CB1
(Optional)
(Not available with separate
rectifier feed option)
77..11..11 CCoonnttrrooll PPaanneell
The control panel is used to set up and control the UPS, and to monitor UPS operation. For a description of the
UPS control panel functions, see paragraph 7.2 Using the LCD Control Panel or paragraph
7.6 Using the Color Touchscreen Control Panel.
77..11..22 CCiirrccuuiitt BBrreeaakkeerrss
Optional circuit breaker (CB1) is used to control the AC input to the UPS rectifier. CB1 is not available with the
separate UPM rectifier feed configuration.
77..22 UUssiinngg tthhee LLCCDD CCoonnttrrooll PPaanneell
The following paragraphs describe the UPS control panel, including controls and indicators, and how to monitor
UPS operation. The control panel (see Figure 101) is located on the front door of the UPS.
UPS Operating Instructions