Eaton Power Xpert 9395 - Figure 104. Load off Screen

Eaton Power Xpert 9395 UPS Installation and Operation Manual 164201725—Rev 15 163
Table 33. Display Menu Operation (Continued)
Function Subfunction
Operation
Com Port Setup The COM Setup screen is used to change and save the settings for the
selected serial communication port. The COM port number selected from the
COM Port Setup screen displays. If the changes are not wanted, use the
ABORT pushbutton to return to the COM Port Setup screen. Use the up or
down arrow pushbutton to highlight the setting to be changed. Use the return
arrow pushbutton to toggle through the values for the setting to make the
change. Press SAVE or ABORT. Once the action is completed, the COM Port
Setup screen is displayed.
Controls See paragraph 7.2.8 System Status Screen and Controls for details.
77..22..77 LLooaadd OOffff SSccrreeeenn
The Load Off screen (Figure 104) is displayed when the LOAD OFF pushbutton is selected from the main menu
bar, the UPS Control Command screen, or the Bypass Control Command screen. This screen allows the LOAD
OFF process to be aborted if the LOAD OFF pushbutton was pressed accidentally. For Load Off procedures,
see paragraph 7.3.24 Using the UPS LOAD OFF Pushbutton or Command or paragraph
7.4.27 Using the UPS LOAD OFF Pushbutton or Command for multiple UPS distributed bypass operation.
Figure 104. Load Off Screen
HOLD LOAD OFF BUTTON FOR3SECONDS
TO TURN OFF LOAD
LOAD OFFCANCEL
77..22..88 SSyysstteemm SSttaattuuss SSccrreeeenn aanndd CCoonnttrroollss
Press the CONTROLS pushbutton on the main menu bar to display the System Status screen. Online
operation, transfer to bypass, charger control, UPM startup and shutdown, and LOAD OFF commands are
controlled through this screen. In addition, the screen displays the current status of the UPS, indicates whether
the UPS is in Maintenance Bypass or Bypass, and displays the state of the UPM and battery charger.
Figure 105 shows the System Status screen.
Use the
or pushbutton on the System Status menu bar to highlight the command screen desired, then
press the CONTROLS pushbutton to display the command menu screen.
Table 34 lists the typical System Status Screen Messages that are displayed during UPS operation.
UPS Operating Instructions