Eaton Power Xpert 9395 - Page 185

162 Eaton Power Xpert 9395 UPS Installation and Operation Manual 164201725—Rev 15
Table 33. Display Menu Operation (Continued)
Function Subfunction
Operation
Change Password The Change Password screen allows the System Setup Level 1 password to
be changed. Select CHANGE PASSWORD from the System Setup Level 1
menu to display the Change Password screen. Use the left or right arrow
pushbutton to select the password character position. Use the up or down
arrow pushbutton to change the password character. Once the new password
is entered, press the DONE pushbutton. The Change Password Save screen is
displayed.
Change Password Save The Change Password Save screen lets you save the new password, retry
another password, or abort the password change. Press SAVE, RETRY, or
ABORT. If SAVE or ABORT is pressed, the action is completed, and the
System Setup screen displays. If RETRY is pressed, the Change Password
screen is redisplayed.
Time Format The Time Format Setup screen allows the selection of either month/day/year
or day/month/year formats for display on the screen and for logging events in
the Event and History Logs. Select SET DATE AND TIME from the System
Setup Level 1 menu to display the Time Format Setup screen. Use the up or
down arrow pushbutton to highlight the desired format, then press the
SELECT pushbutton to display the Set Date and Time screen. To return to the
System Setup screen, press the ESC pushbutton.
Set Date and Time MM/DD/
YYYY
The Set Date and Time MM/DD/YYYY screen allows the internal date and
time of the UPS to be set in the month/day/year format. The date and time
information is used for display on the screen and for logging events in the
Event and History Logs. Use the left or right arrow pushbutton to highlight the
setting to be changed. Use the up or down arrow pushbutton to make the
change. When finished making changes, use the left or right arrow pushbutton
to highlight SAVE and the up or down arrow pushbutton to select YES. To
complete the save function and return to the System Setup screen, select the
return arrow pushbutton.
Set Date and Time DD/MM/
YYYY
The Set Date and Time DD/MM/YYYY screen allows the internal date and
time of the UPS to be set in the day/month/year format. The date and time
information is used for display on the screen and for logging events in the
Event and History Logs. Use the left or right arrow pushbutton to highlight the
setting to be changed. Use the up or down arrow pushbutton to make the
change. When finished making changes, use the left or right arrow pushbutton
to highlight SAVE and the up or down arrow pushbutton to select YES. To
complete the save function and return to the System Setup screen, select the
return arrow pushbutton.
Com Port Selection The Com Port Setup screen allows selection of the serial COM port to set up.
Select COM PORT SETUP from the System Setup Level 1 menu to display
the COM Port Setup screen. Use the up or down arrow pushbutton to highlight
the COM port to be set up, then press the SELECT pushbutton. To return to
the System Setup screen, press the ESC pushbutton.
UPS Operating Instructions