INSTALLATION
Eaton 5130 Rack/Tower UPS (1000–3000 VA) User's Guide S 164201730 Rev 4
www.eaton.com/powerquality
22
Connecting the UPS Internal Battery
To ensure proper battery operation:
1. Verify that the UPS is off and unplugged.
2. Connect the internal battery connectors by firmly pressing the
connectors together (see Figure 2).
1
2
Figure 2. Connecting the Internal Battery Connectors
NOTE A small amount of arcing may occur when connecting the batteries. This is normal
and does not damage the unit or present any safety concern.
3. Install the UPS front cover and snap into place (see Figure 3).
1
2
Figure 3. Installing the UPS Front Cover
4. Continue to the following section, “UPS Setup.”
To Next Page
Loading...
