OPERATION
Eaton 5130 Rack/Tower UPS (1000–3000 VA) User's Guide S 164201730 Rev 4
www.eaton.com/powerquality
36
Starting the UPS on Battery
NOTE Before using this feature, the UPS must have been powered by utility power at least
once.
To turn on the UPS without using utility power, press and hold the
button for two seconds. The UPS starts up in Battery mode and
supplies battery power to your equipment.
Turning the UPS Off
NOTE Pressing the button while the UPS is in Battery mode causes the UPS to shut
down immediately.
To turn off the UPS:
1. Prepare your equipment for shutdown.
2. Press and hold the
button for two seconds. The UPS transfers to
Standby mode (if utility power is available) and removes power from
your equipment.
3. Unplug the UPS.
If you do not unplug the UPS, it remains in Standby mode.
To Next Page
Loading...
