10
4.0 Operation
This section describes:
• The UPS front panel • Standby mode
• Turning the UPS on and off • Diagnostic tests
• Starting the UPS on battery
4.1 UPS Front Panel
The UPS front panel indicates the UPS status and also identifies potential power problems. Figure
7 shows the UPS front panel indicators and controls.
Figure 7. UPS Front Panel
NOTE
If the alarm beeps or if the indicator is on, see Table 8 in Section 10.0 to identi-
fy and correct the problem. To configure parameters through the front panel, see Section
5.0 "Configuration".
Display Mode
To view the UPS current settings, press the
↵↵
button for one second and release. Use the
↵↵
button to scroll through the list of settings, which appear in the following order:
LCD Message Description
I/P VOLT= xxx.xV Input voltage.
Bypass V= xxx.xV Bypass voltage
Bypass F= xx.xHZ Bypass frequency
O/P VOLT= xxx.xV Output voltage.
O/P FREQ= xx.xHZ Output frequency.
O/P Load = x% Approximate percentage of UPS load capacity being used
by the protected equipment.
O/P Watt= xW Output watts.
O/P VA= xVA Output VA.
O/P Cur= x.xA Output current.
BAT VOLT= xx.xV Battery voltage.
BAT CHARGE= xxx% Approximate percentage of battery capacity remaining.
BackUp Time= xxxM Approximate battery time remaining in minutes. The display
changes to seconds after one minute (Backup Time= xxxS).
CPU Version x.xx Firmware revision level.
NOTE The UPS exits Display mode automatically after five seconds if the
↵↵
button is not
pressed. Pressing the
↵↵
button for 3 seconds will lock the display at the present
parameter. Pressing again for 3 seconds releases the meter.
LCD Panel
Power On Indicator
Alarm Indicator
On Battery Indicator
Scroll
Button
On/Off
Button
Enter
Button
Bypass Indicator
To Next Page
Loading...
