Eaton Powerware 9170+ - Power and Battery Module Installation

UPS STARTUP
EATON Powerware
®
9170
+
UPS (3–18 kVA) User’s Guide S 164201393 Rev C www.powerware.com
68
Power and Battery Module Installation
To install the power and battery modules into the Powerware 9170
+
cabinet:
1. Remove the front cover(s) of the cabinet.
The covers have spring latches on the left and right sides that hold
them in place.
NOTE Place battery modules below all power modules in the UPS cabinet. Two battery
modules (side-by-side) are required to complete each battery string.
2. Insert the battery modules into the cabinet.
Push each module firmly until the front latch snaps to secure the
battery module (see Figure 49). Repeat for each additional battery
module.
NOTE All power modules in the Powerware 9170
+
UPS cabinet must be of the same type:
Split-phase power modules have brown labels; universal (single-phase) power modules have
black labels. Do not mix brown and black modules in the same UPS cabinet.
NOTE Do NOT install more than seven power and/or optional battery charger modules in
the system.
3. Insert the power modules into the upper slots of the cabinet. To
insert a power module:
Lower the front slightly and lift the rear edge over the safety stop
on the center support rail. Keep the module handle extended until
the module is fully inserted (see Figure 49).
Raise the power module handle to secure the module into the
cabinet. Be sure the handle latch snaps into place. Tighten the
thumbscrew on the handle.