Eaton PowerXL DC1 20 Series - Page 71

3 Installation
3.3 Mount ing
DC1…20… and DC1…OE1 Variable Frequency Drives 02/20 MN040059EN www.eaton.com 67
3.3.3.2 Fixing on a mounting rail
As an alternative to screw fixing, DC1 variable frequency drives with sizes
FS1, FS2 and FS3 and a degree of protection of IP20 can also be mounted on
a mounting rail as per IEC/EN 60715.
Figure 28: Mounting rail conforming with IEC/EN 60715
 To do this, place the variable frequency drive on the mounting rail from
above [1] and press it down until it snaps into place [2].
Figure 29: Fixing on a mounting rail
￫
If you use EMC mounting adapters (DX-EMC-MNT-…), use a tall
mounting rail (15 mm) preferably.
￫
If you use EMC mounting adapters (DX-EMC-MNT-…), use a tall
mounting rail (15 mm) preferably.
35
1
7.5
15
1.38”
0.04”
0.29”
0.59”
2
1
VAR
EMC
VAR
EMC