Eaton PowerXL DH1 - Page 53

33
Chapter 6—Installation requirements
POWERXL SERIES VFD MN040002EN—February 2018 www.eaton.com
FR1 mounting instructions
Step 1: Lift the drive out from the carton. Remove
the packaging.
Step 2: Attach the drive to the mounting plate with four
M5x15 or 3/16 inch screws and four M5 or 3/16
inch nuts. The opening dimensions on the mounting
plate should follow required dimensions (refer
to the drive mounting template printed on the
outsidecarton).
Screw: Four M5x15
or 3/16 inch
Nut: Four M5
or 3/16 inch
FR2 mounting instructions
Step 1: Lift the drive out from the carton. Remove
the packaging.
Step 2: Attach the drive to the mounting plate with four
M5x15 or 3/16 inch screws and four M5 or 3/16
inch nuts. The opening dimensions on the mounting
plate should follow required dimensions (refer
to the drive mounting template printed on the
outsidecarton).
Screw: Four M5x15
or 3/16 inch
Nut: Four M5
or 3/16 inch