Eaton PowerXL DH1 - Page 54

34
Chapter 6—Installation requirements
POWERXL SERIES VFD MN040002EN—February 2018 www.eaton.com
FR3 mounting instructions
Step 1: Lift the drive out of the carton. Remove
thepackaging.
Step 2: Attach the drive to the mounting plate with four
M6x15 or 1/4 inch screws and four M6 or 1/4 inch
nuts. The opening dimensions on the mounting
plate should follow required dimensions (refer
to the drive mounting template printed on the
outsidecarton).
Screw: Four M6x15
or 1/4 inch
Nut: Four M6
or 1/4 inch
FR4 mounting instructions
Step 1: Lift the drive out of the carton with the cardboard.
Remove the packaging.
Step 2: Attach the drive to the mounting plate with four
M8x15 or 3/8 inch screws and four M8 or 3/8 inch
nuts. The opening dimensions on the mounting
plate should follow required dimensions (refer
to the drive mounting template printed on the
outsidecarton).
Screw: Four M8x15
or 3/8 inch
Nut: Four M8
or 3/8 inch