53
PTO Operation
Eaton Hybrid Countershaft PTO Operation
Stationary Mechanical PTO Operation
The transmission countershaft PTO is used in this application.
To engage the PTO for stationary operation perform the following steps:
1. Apply the parking brake.
2. Depress the service brake.
3. Select “D” on the Shift Control (this stops countershaft rotation for PTO engagement).
4. Engage the PTO.
5. Select “N” on the Shift Control.
6. Release the service brake to engage the clutch and the PTO.
7. Raise engine speed as required to operate PTO.
Mobile Mechanical PTO Operation
The Transmission countershaft PTO is used in this application and provides limited mobile operation in the start gears.
To engage the PTO for mobile operation perform the following steps:
1. Depress the service brake.
2. Release the parking brake.
3. Select “D” on the Shift Control (this stops countershaft rotation for PTO engagement).
4. Engage the PTO.
5. Select “D”, “MANUAL”, “Neutral” or, “Reverse”, as required for vehicle movement.
6. Release the service brake to engage the clutch and the PTO.
7. Raise the engine speed as required to move vehicle / operate PTO.
Engine-off Power Take-Off (ePTO) Operation
The ePTO provides standard hydraulic functions without continuous diesel engine operation. The PTO drive power is provided by
the hybrid motor and hybrid batteries. If the hybrid batteries become depleted, the diesel engine will automatically start to
recharge the batteries, while providing PTO drive power. Once the batteries are fully charged, the engine will shut down automat
-
ically.
ePTO Startup Procedure:
1. Apply the parking brake.
2. Turn key to ON position. Do NOT start the engine.
3. Push and release “ePTO” on shift console.
4. Use the hydraulic controls in the normal manner.
Note: Refer to Truck Equipment Manufacturer/Body Company manuals for proper use of PTO tools and equipment.
To Next Page
Loading...
Need help?
General
