76
Change Log
Change Log
Change Control Log
Last Revised Date Description of Clarifications and Updates
August 2017 Added Endurant Transmission.
February 2016 Added Table information for Heavy-Duty Manual and Fuller Advantage Series transmissions.
March 2014 Added EP3 Model information to Heavy-Duty Automated PTO Configurations section.
Added EN3 Model information to Heavy-Duty Automated PTO Configurations section.
November 2013 Added Fuller Advantage Model PTO information.
Added the note “Transmission rated at a continuous 500 lb-ft at the countershaft. Maximum
intermittent torque at the countershaft is 750 lb-ft.” to the following sections:
Heavy-Duty Manual Transmission - RT Linehaul
Heavy-Duty Manual Transmission - RT Vocational
Heavy-Duty Manual Transmission - RT Performance
Heavy-Duty Manual Transmission - FR Series
Heavy-Duty Manual Transmission - Auxiliary Transmission
Heavy-Duty Automated - 10-Speed
Heavy-Duty Automated - UltraShift® PLUS - VCS and VMS
Heavy-Duty Automated - 13/18/16-Speed
March 2013 Added UltraShift PLUS LSE Model PTO information
UltraShift® PLUS - PTO Inputs and Configurations section:
Removed - “Note: The active signal will illuminate the “Mode” indicator only on the Eaton® push
button console when the transmission direct drive gear is engaged for split shaft PTO operation.”
Medium- and Heavy-Duty Gen 3 - PTO Inputs and Configurations:
Removed - “Note: The active signal will illuminate the “Mode” indicator only on the Eaton® push
button console when the transmission direct drive gear is engaged for split shaft PTO operation.”
To Next Page
Loading...
Need help?
General
