EB TECHNOLOGY START-S1XL v2 - Remote Control Code Memorisation; Programming New Remote Control Codes

-11-
START-S1XL
Operating Guide
3.2 Remote control: code memorisation
The control unit has a BUTTON P1toprogramtheworkingtimeandthememorizationofthecodes.
IfyoumemorizeaSMILE-C,makesurethatallbuttonshaveacodeotherwiseyoucancreateacode.Incase
youwanttomemorizearollingcoderemotecontrol(forex.SMILE-H)youdon’tneedtocreateacode.The
outputofthecontrolunitsshouldbedeactivated,nocontactsavailableandthelightsshouldbeturnedoff.
1
Press and release BUTTON P1inthecontrolboard,LED L1willlitonfor6seconds.Then
2
Press (with 6 seconds) one button of the remote control which should be associated to the
command OPEN (START). Led L1will ash for 5 times to conrm the operation and then it
ashesanditwillashnormallyasatthebeginning.REMOTECONTROLmemorized.
Press(with6seconds)onebuttonoftheremotecontrolwhichshouldbeassociatedtothecommandOPEN
(START).IfLEDL1willashimmediately(without5ashes)itmeansthatthememoryisfullanditcannot
acceptmoreremotecontrols.Thememorycapacityis22remotecontrolsof20bit,ifyouneedmoreyouhave
toinstallanexternalreceiver(forexampleRX2orRX4withamemorycapacityupto3000differentcodes.
Ifyouarenotsureofthememorization,startfrompointno.1butbeforeyouhavetocancelthememory.
1
Press and release button P1inthecontrolboard,LED L1willlitonfor6seconds,Then
2
Press and release (in 6 seconds) button P1inthecontrolunit,
LED L1willlitonfor6seconds.Then
3
Thenin6secondspressthebuttonoftheremotecontrolwhichshouldbeassociatedtothecommand
CLOSE ( we suggest the 2nd channel).
The logic is CLOSE-STOP-CLOSE... and it cannot be changed LedL1willashfor5timestoconrm
theoperationandthenitashesanditwillashnormallyasatthebeginning.REMOTECONTROL
memorized.
The logic Is CLOSE-STOP-CLOSE... and it cannot be changed
Memorisetherstchanneloftheremotecontrolforthecommand OPEN (START)
Memorisethesecondchanneloftheremotecontrolforthecommande CLOSE