EBARA EVMSU - Pump Specifications and Materials

EBARA Pumps Americas Corporation
www.pumpsebara.com
5
rev. 01/19
7. PRODUCT SPECIFICATIONS
EVMSU(L)1-3-5-10-15-20
025101531025101531ezis lanimoN
HP
Capacity
Total Head
Type of liquid
Maximum working pressure
Liquid temperature range
Suction
Discharge
Impeller
Intermediate casing
Liner ring
Bottom casing
Casing cover
AISI 304 (EN 1.4301)
AISI 316L (EN 1.4404)
AISI 329A (EN 1.4462)
Shaft sleeve bearing
SiC/Carbon/FPM
SiC+Graphite/SiC/FPM
SiC/Carbon/EPDM
SiC+Graphite/SiC/EPDM
FPM
EPDM
Outer casing
Motor bracket
Tie rod
up to 5 HP
from 7 1/2 HP
Base
Oval flange up to 230 PSI
up to 230 PSI
from 230 PSI to 360 PSI
up to 230 PSI
from 230 PSI to 360 PSI
victaulic up to 230/360 PSI
Clamp up to 230/360 PSI
Type
Speed
Power Requirements
Direction of Rotation
Motor Options
Standard
Motor
Liquid
Handling
Clean water (for other clean liquids, consult factory)
2"
1 1/4" 2"
Size
2.9 to 132.1 gpm
24.3 to 860 ft
AISI 316L (EN 1.4404)
O-ring
Die cast aluminium
AISI 304 (EN 1.4301)
AISI 304 (EN 1.4301) + PPS
AISI 304 (EN 1.4301)
AISI 316 (EN 1.4401)
NEMA C/TC/TSC frame, TEFC or ODP enclosure
2-pole, 60 Hz, 3500 RPM
3 Phase, 230/460V or 208-230/460V - Single Phase, 115/230V
Clockwise when viewed from motor end
Consult factory for optional motor types
Cast Iron
Legend:
2"
PUMP
Key
Component
Materials
AISI 316 (EN 1.4401)
EVMSU
AISI 304 (EN 1.4301)
Pipe
connection
EVMSUL
1 1/4"
Round flange
(ANSI compatible raised face)
Loose round flange
(ANSI compatible raised face)
Options
1/2 to 25 HP
Performance
range
Version
AISI 316 (EN 1.4401) + PPS
Die cast aluminium
EVMSUL 1-3-5, EVMSUL 10-15-20 (depending on model)
AISI 431 (EN 1.4057)
Shaft
AISI 304 (EN 1.4301)
Coupling
Shaft Seal
"4/1 1"4/1 1
2"
EVMSU 1-3-5, EVMSU 10-15-20 (depending on model)
Cast Iron
AISI 304 (EN 1.4301)
EVMSU / EVMSUL 5-15-20 (depending on model)
Tungsten carbide
AISI 316 (EN 1.4401)
AISI 316 (EN 1.4401)
230 / 375 PSI (depending on model)
-22°F to 248°F (-30°C to 120°C)