EBARA GS - Page 36

- 36 -
STEP.8
Make drill hole (size:φ5.2mm x 8mm) and tap hole
(size:1/4”UNC x 5mm) in pump bushing(4) aligning
with hole of flange of nut(6) in order to assemble
set screw(7).
STEP.9
Assemble set screw(7) to nut(6)/pump bushing(4).
STEP.10
Assemble pump bushing(4) to motor bushing(2).
STEP.11
Assemble bracket(12) to motor(1).
STEP.12
Insert fixing ring of mechanical seal (19) into
casing cover(18).
STEP.13
Assemble casing cover(18) to bracket(12).