The brake system needs routine inspections and maintenance
at certain levels. Refer to table 21 for more information.
^
WARNING
Brakes are a critical safety component. Contact an EBR dealer
for brake repair or replacement. Improperly serviced brakes
can adversely affect brake performance, which could result in
death or serious injury.
These brake tasks may include:
1. Inspecting front and rear brake pads and brake disks
for wear.
2. Checking the fluid level in the front and rear master
cylinder reservoirs.
Stand motorcycle upright and insure that
the level is between the LOWER and UPPER marking. See
figure 38 for front and figure 39 for the rear.
3. Replacing the front and rear brake pads and pin.
4. Changing the brake fluid and having the brakes
serviced. Use only D.O.T. 4 Hydraulic Brake Fluid. Use
AMSOIL® Series 600 racing DOT4 racing Brake Fluid or
equivalent. Always take your motorcycle to an EBR Dealer for
brake system maintenance.
Figure 38. Front Brake Fluid Reservoir.
To Next Page
Loading...