The rear shock absorber requires inspections and
maintenance at proper mileage intervals. Refer to Table 21.
• Inspect shock absorber for oil leaks.
• Inspect shock eye bushings for deterioration
• Check for loose mounting hardware.
See an EBR dealer for all shock absorber repairs.
Refer to Table 21. Spark plugs require inspection and
replacement at specified mileage.
^
CAUTION
Do NOT pull on any electrical wires. Pulling on electrical wires
may damage the internal conductor causing high resistance,
which may result in minor or moderate injury.
The engine is equipped with plug-top coils. To inspect the
spark plugs, the coils must be removed. See the video service
manual for proper service procedure.
See Table 2. Only the specified spark plugs with the proper
gap should be installed.
Spark timing is advanced electronically as engine speed
increases to suit starting, low speed and high speed
requirements.
Idle speed is monitored and
controlled by the Electronic
Control Module (ECM) and
Idle Air Control (IAC) and is
Table 19. Engine Idle speed.
The wheel bearings are sealed units. No greasing or
maintenance is required.
Inspect wheel bearings each time the wheel is removed.
107
To Next Page
Loading...