EasyManua.ls Logo

EBR 1190 SX - Clutch Hand Lever

EBR 1190 SX
142 pages
Print Icon
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Loading...
Clutch Hand Lever
^
WARNING
Do not position fingers between the hand control lever and
the handlebar grip. Improper hand positioning can impair
control lever operation and cause loss of vehicle control,
which could result in death or serious injury.
See Figure 6. the clutch hand lever is located on the left
handlebar and is operated with the fingers of the left hand.
1. Slowly pull clutch hand lever in against the
handlebar grip to fully disengage the clutch.
2. Shift to first gear using the gear shift lever. See
OPERATION, Gear Shift Lever. Slowly release the clutch hand
lever to engage clutch.
Horn Switch
See Figure 6. The horn is operated by pushing on the horn
switch located on the left hand controls.
Headlamp High/Low Beam Switch
The headlamp high/low beam switch is located on the left
hand controls. The switch has two positions to activate the
headlamps high or low beams.
See Figure 6. Press the top of the headlamp high/low beam
switch to activate the high beam.
Press the bottom of the headlamp high/low beam
switch to return to low beam.
See Figure 6. The (blue) high beam indicator lamp will
illuminate when the high beam is on.
Passing Lamp Switch
See Figure 6. The passing lamp switch is located on the front
of the left hand controls. Pressing the switch when the
headlamp dimmer switch is set to low beam will momentarily
flash the high beam headlamp.
Turn Signal Switch
See Figure 6. The left/right turn signal switch is located on
the left hand controls and activates the front and rear turn
signal flashers.
Push the turn signal switch to the right to activate
the right front and rear turn signal flashers.
38

Table of Contents