EasyManua.ls Logo

EBR 1190 SX - Pre-Riding Check List

EBR 1190 SX
142 pages
Print Icon
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Loading...
2. Up to 620 mi (1000 km), vary the engine speed and
avoid operating at any steady engine speed for long periods.
Engine speed up to 7500 rpm in any gear is permissible.
3. Drive slowly and avoid fast starts at wide throttle
until the engine has warmed up.
4. Avoid lugging the engine by not running the engine
at very low speeds in higher gears.
5. New brakes need to be bedded-in. Avoid stops from
very high speeds for the first 200 miles (300 kilometers).
Proper seating of the pads can be accomplished by using light
brake pressure for the first few stops, letting the system cool,
then doing several stops using moderate to firm brake
pressure.
PRE-RIDING CHECK LIST
^
WARNING
Read the CONTROLS AND INDICATORS section before riding
your motorcycle. Failure to understand the operation of the
motorcycle could result in death or serious injury.
Before riding your motorcycle at any time, make a general
inspection to be sure it is in safe riding condition.
^
WARNING
Stop the engine when refueling or servicing the fuel system.
Do not smoke or allow open flame or sparks near gasoline.
Gasoline is extremely flammable and highly explosive, which
could result in death or serious injury.
^
WARNING
Avoid spills. Slowly remove filler cap. Do not fill above bottom
of fill plate, leaving air space for fuel expansion. Secure filler
cap after refueling. Gasoline is extremely flammable and
highly explosive, which could result in death or serious injury.
^
WARNING
Use care when refueling. Pressurized air in fuel tank can force
gasoline to escape through filler tube. Gasoline is extremely
flammable and highly explosive, which could result in death
or serious injury.
61

Table of Contents