EBS 6900 - Printer Safety Precautions

The BOLTMARK
®
II‑series PrinTers
Basic OPeraTing insTrucTiOns
42018/02/27#2.0EN
Safety inStructionS
• A printer user can enjoy OPERATOR and ADVANCED OPERATOR privileges.
The SERVICEMAN access level, which oers access to all service procedures, is de-
signed exclusively for the manufacturer’s authorized service sta.
• The printer should be operated by trained personnel. It is recommended that the printer be
supervised during operaon.
• Do not print on objects whose temperature exceeds 100°C (212°F) at the me of labeling.
• Make any manipulaons in the electrical part of the printer only when the power is turned
o.
• Never direct the printhead outlet towards persons or animals. Even if the printer is shut
down.
• Wear protecve clothing and goggles while performing any operaons in the ink system
and the printhead.
• While an iModule
®
and boles are being installed/replaced in the consumables compart-
ment be careful not to get wounded with the needles that are part of their connectors.
• Do not use plasc vessels for washing. Drip pans of metal are recommended.
• If you need to disconnect the printer from the electrical mains, take out power plug from
the mains or set main power switch POWER to the ”O” posion.
• Do not use the printer if it is not fully operaonal.
• in case of accident
When ink spills, wipe the spilled liquid with absorbent material and dispose of it following the
re and health and safety at work regulaons.
Take the splashed clothes o as soon as possible.
If eyes or skin get irritated:
• EYES need rinsing with running water over 15 minutes; then contact
an ophthalmologist,
• SKIN needs washing with water and soap.