EBS 6900 - Printer Safety: Fire and Environment; Fire Protection Guidelines

The BOLTMARK
®
II‑series PrinTers
Basic OPeraTing insTrucTiOns
5 2018/02/27#2.0EN
Safety inStructionS
• fiRe pRotection
The instrucons described in the data sheets for every ink or solvent should be followed strictly.
• Place a re exnguisher (designed for exnguishing electrical equipment and ammable
solvent res) near the printer.
• Do not print in the areas where an explosion hazard exists.
• Do not use open ames or sparking devices in the printer work area.
• Do not leave ink, solvent or wash-up in open containers.
• Before coming close to ammable liquids touch a grounded metal object (e.g. the grounded
printer housing).
• Ensure good venlaon in the area where the printer is installed (especially near the print-
head) and where consumables are stored.
• WoRking conditions
• Connect the printer to an electric outlet equipped with protecve grounding.
• Supply voltage: 100 ‑ 240 VAC, 50/60 Hz.
• Working temperature:
+5 ‑ +40 ºC (+41 ‑ +104 ºF) for stac operaon.
+15 ‑ +40 ºC (+59 ‑ +104 ºF) for dynamic operaon.
• Relave humidity: up to 90% without condensaon.
• Connect the protecve pin of the printer to a grounded element of the industrial plant, e.g.
to a belt conveyor. This is required especially when the printer is connected to a telecommu-
nicaons network.
• Discharge vapors via an unobstructed pipe to the outside of the building.
• Ensure free access to the printer, especially to the main power switch POWER which is
a safety switch.
• Put the printer in a horizontal posion on an EBS Ink Jet Systeme table or stand or hang it
on a rack; the printer should be protected against movement.
• Put the photodetector and the printhead in a convenient place to label objects comfortably;
the printhead should be situated in a place where no shock or vibraon occurs.
• The printer is equipped with a built-in, non-replaceable lit-manganese baery. The baery
must not be removed, replaced, crushed, punched, thrown into water or re.